Fittings And Fasteners; Lights; Switches; Battery - ATV 250 Manual

tion when released. Repair as necessary for proper
operation.
Fittings and Fastenerns
Always check the tightness of chassis fittings and
fasteners before a ride. Refer to the Service. Manual for
correct tightening torque.

Lights

Check the headlight and taillight to make sure they
are in working condition. Repair as necessary for proper
operation.

Switches

Check the Operation of the headlight switch, en-
gine stop switch and any other switches. Repair as nec-
essary for proper operation.

Battery

. The battery is an enclosed one and unnecessary
to fill water(see page)
. Don't take off the closing bolt when charging.
. When charging,please obey the charging current
and time as shown on the following table.
Charge criteria:Charge the battery with ten percent
of capacity of battery for 5 to 10hours, or quickly charge
the battery with 2A to 3A for 2 hours.

Tire

The size and type (in low pressure condition) of
hollow tire used for 250ATV are listed below.
Front wheel
Size AT22*7-10
Type Zheng xin or wuxi
warning
Use of improper tires on this ATV, or operation of
this ATV with improper tire pressure may increase your
risk of accident.
Use of improper tires on this ATV, or operation of
this ATV with improper tire pressure may cause loss of
control.
Pay attention to choose the Size and type of used
tire according to the description in the above chart and
make sure that the tire pressure is normal.
2.The tires should be set to the recommended
pressure.
Front 20KPa(0.20kgf/cm
Rear 25KPa(0.25kgf/cm
Check and adjust tire presssure when the tires are
cold.
Tire Pressure below the minimum specified could
cause the tire to dislodge from the rim under severe rid-
ing conditions, the following are minimums:
Front 17KPa(0.17kgf/cm
Rear 22KPa(0.22kgf/cm
Higher pressures may cause the tires to burst. In-
flation could cause the tires to burst.

How to measure tire pressure

-12-
Rear wheel
AT22*10-10
Zheng xin or wuxi
2
2,2.8pai)
2
2,3.6pai)
2
)
2
)