Options Button - Zanussi FLE 1016 W Instruction Booklet

Important! If you accidentally press the SKIP/RESET
button more than once, the memory will be cleared.
To cause the washing machine to drain the water,
select any washing programme by means of the
FABRIC button, then press SKIP/RESET three
times in order to select the DRAIN position (only the
DRAIN light will remain lit).

6 OPTIONS button

Press this button to select the following options:
• PREWASH: select this option if you wish your
laundry to be prewashed before the main wash (not
available for wool).
The prewash ends with a short spin at 650 rpm in
programmes for cotton and synthetic fabrics, whereas
in the programme for delicate fabrics the water is only
drained.
• SUPER RINSE: this option can be selected with all
programmes except the wool programme.
The machine performs 4 rinses instead of 3. This
option is recommended for people who are allergic to
detergents, and in areas where the water is very soft.
• QUICK WASH: for laundry that is only slightly
soiled (not for wool).
The washing time will be reduced according to the
type of fabric and the selected temperature.
The PREWASH and QUICK WASH options cannot be
selected together.
7 START/PAUSE button
This button has three functions:
• Start: after you have selected the desired programme
and options, press this button to start the washing
machine. The light above the button will stop flashing
and remain lit.
• Pause: when you press this button again, the
programme in progress is interrupted. The light above
the button will start flashing. To restart the programme,
press the button again.
When you PAUSE the cycle, the DOOR LOCKED
light goes out, and it becomes possible to open the
door, provided
• the washing machine is not in the heating phase
beyond 40°C;
• the level of the water is not high;
• the drum is not turning.
Important! You must set the washing machine to
PAUSE before you make any change in the programme
in progress.
• Draining of water and spinning after the execution of
programmes with the RINSE HOLD option.
8 SKIP/RESET button
This button performs two functions:
- Clears the memory
- Selects special programmes
At the end of every programme the RESET button must
be pressed once or repeatedly to clear the programme
memory. All the programme phase indicator lights must
be off.
If the previous programme is not cleared, an audible
signal will sound, when you switch the machine on.
Selecting a special programme:
A wash programme must be selected in the normal way.
(START button not pressed)
7