Options Button - Zanussi FE 925N User Manual

132992210.qxd 4/7/03 10:29 AM
• Drain only
- Press the RESET button
the DRAIN light
START/PAUSE button.
Important! If you accidentally press the RESET
button more than once, the programme is
cancelled. To cause the washing machine to
drain the water, select any washing programme
by means of the FABRIC button
RESET three times in order to select the DRAIN
position (only the DRAIN light
lit).
OPTIONS
6 button
Press this button to select the following options:
• PREWASH : select this option if you wish your
laundry to be prewashed before the main wash
(not available for wool).
The prewash ends with a short spin in
programmes for cotton and synthetic fabrics,
whereas in the programme for delicate fabrics the
water is only drained.
• SUPER RINSE
with all programmes except the wool
programme. The machine performs 4 rinses
instead of 3. This option is recommended for
people who are allergic to detergents, and in areas
where the water is very soft.
• QUICK WASH
laundry (not for wool).
The washing time will be reduced according to the
type of fabric and the selected temperature.
7 START/PAUSE button
This button has three functions:
• Start: after you have selected the desired
programme and options, press this button to start
the washing machine. The light above the button
will stop flashing and remain lit.
• Pause: when you press this button again, the
programme in progress is interrupted. The light
above the button will start flashing. To restart the
programme, press the button again.
Important! You must set the washing machine to
PAUSE before you make any change in the
programme in progress.
• Draining of water and spinning after the
execution of programmes with the RINSE HOLD
option .
Pagina 9 (Nero/Process Black pellicola)
once, so as to cause
to light up, then press the
, then press
will remain
: this option can be selected
: to be used for lightly soiled
8 SKIP/RESET button
At the end of a programme, you must press this
button once or repeatedly, in order to clear the
contents of the memory; otherwise, the next time
you switch the washing machine on, the audible
warning signals relevant to the end of the previous
cycle will be given.
You can also press the RESET button to exclude
one or several phases of the programme which is
running, as indicated below.
- set the washing machine to PAUSE by
pressingthe START/PAUSE button (the relevant
light will flash);
- press the RESET button once or several
times, until the required phase(s) is(are) cancelled
(the light next to the symbol of the phase(s) will go
out).
Example:
This button allows you also to select special
programmes, such as RINSES, SPIN and DRAIN.
• If the machine is already switched on because it
has just performed a washing programme, proceed
as follows:
- depress RESET once or repeatedly to cancel the
previously performed programme (all the phase
indicator lights must be off);
- select the type of fabric by means of the relevant
button;
- select the special programme:
• RINSES AND SPIN
Depress RESET once, the pilot light
goes out.
• SPIN
Depress RESET twice, the pilot lights WASH
and RINSES go out.
•DRAIN
Depress RESET three times, the pilot lights
WASH , RINSES
9
In this case, the spin
(at the speed provided
for the selected type of
fabric) will be
performed.
(WASH)
and SPIN go out.