Delay Start; Options Button - Zanussi ZWA 5130 Instruction Manual

RINSE HOLD position: when you choose this
option, the machine will not drain the water of the
last rinse which could crease the laundry.
At the end of the cycle, the START/PAUSE button
light will flash to indicate that the water must be
drained. To complete the cycle, choose one of the
following options:
•
Draining and spin:
-
Press the START/PAUSE button. The ma-
chine will drain the water, then spin the laundry
at the maximum speed provided for the selected
programme.
-
Select spin speed by means of button 5, and
press the START/PAUSE button.
•
Drain only:
-
Press the SKIP/RESET button once, so as to
cause the DRAIN light to illuminate, then press
the START/PAUSE button.

6 OPTIONS button

Press this button to select the following options:
PREWASH : select this option if you wish your
laundry to be prewashed before the main wash
(not available for wool and hand-wash cycle).
The prewash ends with a short spin at 650 rpm in
programmes for cotton and synthetics fabrics,
whereas in the programme for delicate fabrics the
water is only drained.
ECO : This option can be selected only for
synthetics lightly or normally soiled with a
temperature of 40°C or higher. The washing time
will be prolonged.
QUICK : Suitable for lightly soiled clothes.
This function cannot be used on the wool and
hand-wash programmes.
The washing time is reduced on the basis of the
type of FABRICS and TEMPERATURE which
have been selected.
SUPER RINSE : this option can be selected with
all programmes except the wool programme and
hand-wash. The machine performs 4 rinses instead
of 3. This option is recommended for people who
are allergic to detergents, and in areas where the
water is very soft.
NIGHT CYCLE : This option reduces the noise by
your washing machine while offering the same
washing performances. Thus, you can use your
washing machine at night without being
inconvenienced by the noise. There is no spin
cycle and the last rinsing water is left in the
machine to prevent the washing from becoming
creased if it is not immediately removed from the
drum.

7 Delay start

This option delays start of the program for 30 mi-
nutes to 23 hours. Select the number of hours
after which you want the program to begin by pres-
sing on the pushbutton several times. The time
appears on the display.
8 START/PAUSE button
This button has three functions:
•
Start: after you have selected the desired
programme and options, press this button to
start the washing machine. The light above the
button will stop flashing and remain lit.
•
Pause: when you press this button again, the
programme in progress is interrupted. The light
above the button will start flashing. To restart
the programme, press the button again.
•
Draining and spinning after programmes with
RINSE HOLD option.
When you PAUSE the cycle, the DOOR light goes
out, and it becomes possible to open the lid,
provided
•
the washing machine is not on the heating
phase;
•
the level of the water is not high;
•
the drum is not turning.
Important!
You must set the washing machine to PAUSE
before you make any change in the programme in
progress.
9 SKIP/RESET button
This button performs two functions:
-
Clears the memory.
-
Selects special programmes.
At the end of every programme the RESET button
must be pressed at least once to clear the pro-
gramme memory.
Selecting a special programme:
A wash programme must be selected in the normal
way (START button not pressed).
A normal wash cycle consists of the following
phases PREWASH - WASH - RINSE - SPIN and
is confirmed by the illumination of the corresponding
LED's.
7