Bosch Universal HedgePole 18 Original Instructions Manual page 19

Charger
Weight according to EPTA‑Procedure
01:2014
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Noise/Vibration Information
Noise emission values determined according to EN 62841-4-2:2019 .
Typically the A-weighted noise levels of the product are:
– Sound pressure level
– Sound power level
– Uncertainty K
Wear hearing protection!
Vibration total values ah (triax vector sum) and uncertainty K determined according to EN 62841-4-2:2019
– Vibration emission value a
h
– Uncertainty K
That the declared vibration total value(s) and the declared
noise emission value(s) have been measured in accordance
with a standard test method any may be used for comparing
one tool to another.
That the declared vibration total value(s) and the declared
noise emission value(s) may also be used in a preliminary as-
sessment of exposure.
That the vibration and noise emissions during actual use of
the power tool can differ from the declared values depend-
ing on the ways in which the tool is used especially what kind
of workpiece is processed; and of the need to identify safety
measures to protect the operator that are based on an estim-
ation of the exposure measures in the actual conditions of
use (taking account of all parts of the operating cycle such as
the times when the tool is switched off and when it is running
idle in addition to the trigger time).
Starting Operation
For Your Safety
Before any work on the machine itself (e. g. mainten-
u
ance, tool change, etc.) as well as during transport
and storage, remove the battery from the power tool.
There is danger of injury when unintentionally actuating
the On/Off switch with the locking button.
The blades continue to move for a fraction of a second
u
after the hedge trimmer is switched off.
Do not touch the moving blades.
u
Do not activate switches until battery is fully at-
u
tached.
Bosch Power Tools
AL 1810 CV
kg 0.17
dB(A)
dB(A)
dB
m/s
m/s
Inserting/removing the battery (see figures D
and K)
Note: Using unsuitable batteries can lead to malfunctions of
or cause damage to the power tool.
Insert the charged battery (13) onto the telescopic handle.
Make sure that the battery is fully fitted.
To remove the battery (13) from the power tool, press the
battery unlocking button (14) and pull the battery out to-
wards the cutting blade.
Charging the Battery
Pay attention to the mains voltage. The voltage of the
u
power source must match the voltage specified on the
rating plate of the charger.
The battery is equipped with temperature monitoring that al-
lows charging only in the temperature range between 0 °C
and 35 °C. In this manner, a high battery service life is
achieved.
Note: The battery is supplied partially charged. To ensure
full battery capacity, completely charge the battery in the
battery charger before using for the first time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging procedure
does not cause damage to the battery.
The "Electronic Cell Protection (ECP)" protects the lithium-
ion battery against deep discharging. When the battery is
empty, the product is switched off by means of a protective
circuit: The product no longer operates.
Do not continue to press the On/Off switch after an auto-
matic shut-off of the product. The battery could become
damaged.
Observe the notes for disposal of the battery.
English | 19
AL 1830 CV
0.40
/ II
3 600 HB3 0..
2
2
F 016 L94 063 | (17.11.2020)
/ II
72
86
4
1,1
1,5