LEADING EDGE SAFETY R2000 Instruction Manual page 28

APPENDIX B—ENGAGEMENT ARM SHOCK REMOVAL (CONT.)
E
N
READ AND UNDERSTAND THE ENTIRE SET OF INSTRUCTIONS BEFORE PERFORMING ANY STEP IN THIS PROCESS
G
L
STEP 4
I
S While the Engagement Arm Shock (19) is still mounted to the
machine and before removing any Clevis Joint Snap-In Pin
H
(19a) from the Engagement Arm Shock (19), tightly wind
baling wire around the compressed Engagement Arm Shock
(19), two times and twist baling wire ends together 3 - 4
times.
STEP 5
Press downward slightly the Engagement Arm Assembly (6)
and hold, lift upward on the Locking Mechanism (7) handle to
disengage, release hold of the Engagement Arm Assembly
(6). Completing this step will release any tension from the
Clevis Joint Snap-In Pins (19a) that hold the Engagement
Arm Shock (19) in place.
STEP 6
WARNING—THE CLAW ASSEMBLY CAN DROP AT THIS
STEP—BE SURE TO SECURE THE CLAW FROM
DROPPING OR HAVE ANOTHER PERSON HOLD THE
CLAW FROM MOVING.
Remove the Clevis Joint Snap-In Pins (19a) from both ends
of the damaged Engagement Arm Shock (19) and remove the
Engagement Arm Shock (19).
R2000™ I
NSTRUCTION
M
ANUAL
19a
3-4 TWISTS
6
7
19a
19
27
19
19
19
19a
19a