Table of Contents
Advertisement
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent required, pour it into the
main wash compartment
partment if the selected programme/option it requires
(see more details in "Detergent dispenser drawer").
If required, pour fabric softener into the compartment
marked
(the amount used must not exceed the
«MAX» mark in the drawer). Close the drawer gently.
Select the required programme by turning the
programme selector dial (1)
Turn the programme selector dial to the required pro-
gramme. The green pilot light of the button 5 starts to
flash.
The selector dial can be turned either clockwise or coun-
terclockwise. Turn to position « Off » to reset programme/
switch the machine off.
At the end of the programme the selector dial must be
turned to position «Off» , to switch the machine off.
Caution! If you turn the programme selector dial to
another programme when the machine is working,
the red pilot light of button 5 will blink 3 times to indicate
a wrong selection. The machine will not perform the new
selected programme.
Select the spin speed, the Night Cycle or the Rinse
Hold option by pressing button 2
The washing machine will automatically select the max-
imum spin value provided for the programme you have
chosen. (See "Washing programmes" for the maximum
allowed spin speed).
Press this button repeatedly to change the spin speed, if
you want your laundry to be spun at a different speed. The
relevant light will light up.
Select the available options by pressing buttons 3
and 4
Depending on the programme, different functions can be
combined. These must be selected after choosing the de-
sired programme and before starting the programme.
When these buttons are pressed, the corresponding pilot
lights illuminate. When they are pressed again, the pilot
lights go out. If an incorrect option is selected, the inte-
grated red pilot light of the button 5 flashes for 3 times.
For the compatibility among the washing pro-
grammes and the options see chapter «Washing
Programmes».
or in the appropriate com-
Select the Delay Start by pressing button 6
Before you start the programme, if you wish to delay the
start, press the button 6 repeatedly, to select the desired
delay. The relevant light illuminates.
You must select this option after you have set the pro-
gramme and before you start the programme.
You can cancel or modify the delay time at any moment,
before you press button 5 .
Selecting the delayed start:
1. Select the programme and the required options.
2. Select the delay start by pressing the button 6 .
3. Press button 5 :
– the machine starts its hourly countdown.
– The programme will start after the selected delay
has expired.
Cancelling the delayed start after having started the pro-
gramme:
1. Set the washing machine to PAUSE by pressing but-
ton 5 .
2. Press button 6 once, the light relevant to the selected
delay goes off
3. Press button 5 again to start the programme.
The Delay Start can not be selected with DRAIN pro-
gramme.
Important! The selected delay can be changed only after
selecting the washing programme again.
The door will be locked throughout the delay time. If you
need to open the door, you must set the machine to PAUSE
(by pressing the button 5 ) and then wait a few minutes.
After you have closed the door, press the button 5 again.
Start the programme by pressing button 5
To start the selected programme, press the button 5 , the
corresponding green pilot light stops blinking. The pilot
light corresponding to the running phase illuminates. The
appliance starts operating and the door is locked.
To interrupt a programme which is running, press the
button 5 : the corresponding green pilot light starts blink-
ing.
To restart the programme from the point at which it was
interrupted, press the button 5 again . If you have chosen
a delayed start, the machine will begin the countdown.
If an incorrect option is selected, the red pilot light of the
button 5 blinks 3 times.
7
Hide quick links:
Advertisement
Table of Contents
