Installation; Required Accessories; Preparation - Hornbach C800 Installation And User Manual

Installation

WARNING
Consult a specialist, if there is any doubt on the
load carrying capacity of the installation site.
WARNING
Important safety instructions. Follow all instruc-
tions since incorrect installation can lead to severe
injury.
• Before installing the drive, remove all unneces-
sary ropes or chains and disable any equipment,
such as locks, not needed for powered operation;
• Before installing the drive, check that the door is
in good mechanical condition, correctly balanced
and opens and closes properly;
• Before installation, check if the wall or ceiling
at the installation site has sufficient load carry-
ing capacity. Depending on the wall type at the
installation site, the correct fastening must be
selected in order to ensure a secure fixation.
• After installation, ensure that the mechanism is
properly adjusted and that the drive reverses or
the object can be freed when the door contacts a
50 mm high object placed on the floor
• After installation, ensure that parts of the door
do not extend over public footpaths or roads.
• After installation, ensure that the entrapment
protection system operates as intended.
WARNING
To prevent risks during installation, the installer
must have sufficient knowledge in the following
qualifications:
• Handling of ladders and scaffolding.
• Evaluation of basic structures of a building.
• Handling of tools and machines.
• Handling and installation of fastening equipment.
• Commissioning and operation of products.
If not every qualification can be covered by the in-
staller, seek for a professional installation specialist
to perform the installation.
WARNING
Electrical work and repairs must be performed by a
qualified electrician.
During installation, always observe the national
installation regulations.
WARNING
Always call a trained door systems technician if
garage door binds, sticks, or is out of balance. An
unbalanced garage door may not reverse when
required.
Never try to loosen, move or adjust garage door,
door springs, cables, pulleys, brackets or their hard-
ware, all of which are under extreme tension.

Required accessories

The following accessories (not included) are required,
for a proper installation of the garage door opener:
•
Level
•
Tape measure
•
Chalk or pencil
•
Wrench
•
Stepladder
•
Impact drill
•
Suitable wall anchors
•
Suitable drill bit for wall type at installation site
•
Garage door reinforcement (if required)
•
Batten (4 cm thick, slightly shorter then garage door
width)
•
Emergency door release kit of door supplier (only
for garages without second entry)

Preparation

•
Fiberglass, aluminum or lightweight steel garage
doors require reinforcement before installation of
door opener. Contact your door manufacturer for
reinforcement kit. Install reinforcement kit following
the manufacturer's manual.
•
To avoid installation difficulties, do not run the ga-
rage door opener until instructed to do so.
•
Disable all locks of the garage door. Otherwise the
opener and the door will be damaged when op-
erating the garage door. The garage door opener
prevents the door from being opened without the
appropriate remote control. If your garage has no
second entry, install an emergency door release kit
of your garage door supplier to be able to open the
door in case of malfunction.
•
Remove all ropes connected to garage door before
installation and operation to avoid entanglement.
•
The garage door opener needs a free wall socket
in the vicinity that meets the requirements given in
technical data and all local regulations. The socket
must be freely accessible to cut the garage door
from power supply by unplugging when needed.
Have a qualified electrician install a socket, if none
is available yet.
ENGLISH | 201