Troubleshooting - AEG HC451220EB User Manual

space between it and glass ceramic.
Glass bar is attached to the ceramic
plate.
• Do not put the pots on the glass bar.
• Make sure that the pans and pots do
not touch the glass bar.
6.3 Cleaning the hob
• Remove immediately: melted plastic,
plastic foil, and food with sugar. If not,
the dirt can cause damage to the hob.

7. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
7.1 What to do if...
Problem
You cannot activate or oper-
ate the hob.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
Put the special scraper on the glass
surface at an acute angle and move
the blade on the surface.
• Remove when the hob is sufficiently
cool: limescale rings, water rings, fat
stains, shiny metallic discoloration.
Clean the hob with a moist cloth and
non-abrasive detergent. After
cleaning, wipe the hob dry with a soft
cloth.
Possible cause
The hob is not connected to
an electrical supply or it is
connected incorrectly.
The fuse is released.
You touched 2 or more sen-
sor fields at the same time.
STOP+GO function oper-
ates.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
You put something on the
sensor field .
ENGLISH
Remedy
Check if the hob is correctly
connected to the electrical
supply. Refer to the connec-
tion diagram.
Make sure that the fuse is
the cause of the malfunction.
If the fuse releases again
and again, contact a quali-
fied electrician.
Activate the hob again and
set the heat setting in less
than 10 seconds.
Touch only one sensor field.
Refer to "Daily use" chapter.
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
13