OpticFilm 135 Series Quick Start Guide
1
Connect and Install
Please visit
www.plustek.com/OpticFilm135i/QuickStart
download the software and driver and quick installation guide
for your newly purchased Plustek OpticFilm135i film scanner.
3
Insert the Film Holder
35mm Mounted Film Holder
F
35mm Strip Film Holder
● The film holder should be able to be inserted into the scanner smoothly. Do not
push the film holder hard.
● On the top side of the film holder you can see '35 mm Mounted Film Holder' or
'35 mm Strip Film Holder'. Always keep this side up for correct scan results.
Attention
2
Preference Settings
to
4
Scan Your Film
You may do one of the following:
● Scan with [Positive] or [Negative] or [Custom]
button
● Scan with QuickScan Plus Application
Get started
Activate this checkbox if you do not
want the QuickScan Plus program to
launch after scanning images.
The scanned images will be opened
directly on 3rd party image editing
software.
*Please refer to FAQ part on
the rear side of THIS guide.
This function is only for the infrared
built-in model.
You may select Custom scan mode to adjust
the cropping areas if necessary.
P/NO.: 17-07-2BB1010-C
Need help?
Do you have a question about the OpticFilm 135 Series and is the answer not in the manual?
Questions and answers