Setting The Installation Menu - LG 55WV70MS Easy Setup Manual

Setting the Installation Menu

1
If you press the MENU button on the remote
control for more than five seconds, the main
menu appears and then disappears. The input
data is also displayed in the upper left corner of
the screen.
RGB
3
When the Installation Menu is displayed, select
the item you want.
Installation Menu (V 2.21)
LG Digital Signage Setup
White Balance Adjust
Password Change
Confi guration Cloning
MCU Version V1.02.08
LG Digital Signage Setup (V2.21)
Signage Mode Operation
• 15 Min Force Off
• 4 Hours Off
• Wake On LAN
• Total Set ID
• DPM
• Software Update
• Power On Status
• Input Source Change
• Menu Display
• OSD Display
• Min Volume
• Max Volume
• Power On Default
• Input Source
• Volume
• Aspect Ratio
• Intelligent Auto
• Factory Reset
2
Signage Mode
Operation
15Min Force
Off
4 hours off
Wake On LAN
Total Set ID
DPM
Software
OK
Update
Power On
Status
Input Source
Change
Menu Display
Yes
◄ ►
Yes
OSD Display
Yes
No
Min Volume
1
Max Volume
Yes
No
Power On
STD
Default
Yes
Input Source
Yes
Yes
Volume
0
100
Aspect Ratio
No
OFF
Intelligent Auto If the setting is Yes, Display is automatically
OFF
OFF
Yes
Factory Reset
No
OK
Press the "0" button four times. Press the OK
button.
1 2 3
. , ! ABC DEF
4 5 6
GHI JKL MNO
7 8 9
PQRS TUV WXYZ
0
1/a/ A CLEAR
- * #
Decide to work all functions of 'Signage
Mode Operation' or not.
Turns off the monitor if there is no input for
more than 15 minutes.
"No" is the recommended default value
setting.
Turns off the monitor if there is no input on
the remote control for more than four hours.
"No" is the recommended default value
setting.
Turns on the monitor remotely using LAN.
Sets the maximum value for picture IDs.
Enters energy saving mode if there is no
input signal.
Sets whether to use NSU (Network Software
Update).
Decide to select working status of Monitor
Set when turn on main power.
Decide to change input source or not
by setting 'Input Source Change' as
Yes(Change possible) or No(Change
impossible).
MENU key does not work if 'Menu Display'
is set to No.
Decide to display OSD or not by setting
'OSD Display' as Yes(Mark) or No(No Mark).
Decide 'Min Volume' between changing
range 0 to 100.
Decide 'Max Volume' between changing
range 0 to 100.
With the power turned on, you can set the
'Input Source' and 'Volume' options.
Set whether it is turned on by the set input
source or by the last stored input source.
This sets whether to apply the Volume Level
or not when the power is turned on.
With the power turned on, you can set the
'Aspect Ratio' option with the pre-defi ned
value.
arranged through resolution size when you
change the resolution at the fi rst.
If it is set to No, 'Factory Reset' under
OPTION is disabled.
19
Installation