inelo TachoReader Combo Plus Tutorial page 20

Download from driver card inserted in the tachograph
on (switching on the tachograph).
We recommend to carry out the above step accompanied by the driver of the vehicle.
2. Depending on the selected option:
Option I
·
19
Option II
·
19
After reading the company card, some tachographs may request confirmation of "unlocking".
In this case, "unlock" the tachograph, or "Technical data" and "Activities" will not be downloaded.
Option III
·
19
Old types of tachographs:
For and
19
Option I
3. Connect TachoReader Combo Plus device to the tachograph using a
4. Depending on the selected option:
Option I
·
19
Option II
·
19
Option III
·
19
of the progress bar light up (Fig. bellow);
Click: to start downloading data.
If during the data retrieval the device beeps 4 times and the progress bar moves back to the
beginning, this means that the reading of data will be continued by
can happen on the "old" type of tachograph, where the data download can take up to one hour.
If during data retrieval red LED located in the center of the label lights up for about 4 seconds, and in
this time the device sounds three short beeps, then it goes off for about 2 seconds (repeatedly), this
- insert the driver card into any slot of the tachograph;
- - insert a company card and the driver card to any tachograph slots;
- insert the driver card into any slot of the tachograph;
it may also be required to insert the company card.
19
Option III
- press the button you configured (
- press the button you configured (
- repeatedly press the:
Fig. Data download progress bar.
, or
, or
, button until the EDs on the fields 2
L
at a lower speed. This
TR Combo
Tacho RC cable
.
)
)
and 60
8
20