Engine And Transmission, Removing - Volvo D12D Service Information

Document Title:
Engine and transmission,
removing
Profile:
ART, A35E FS [GB]

Engine and transmission, removing

Op nbr 210-073
88830051 Lifting tool
This operation also includes required tools and times for applicable parts of the following operations:
173 Coolant, change

900 Vacuum pump, connection

WARNING
Changing control units between machines, when troubleshooting or repairing, may not take place for any reason
without reprogramming.
Incorrect individual settings in the control unit may result in personal injury or machine damage.
For reprogramming and read-out of software, see "VCADS Pro User manual".
1. Place the machine in service position.
2. Turn off the electric power with the battery disconnect switch.
NOTE!
If the height between the workshop floor and the overhead crane member is less than 450 cm (15 ft), the engine
hood shall be removed. If higher, the engine unit can be lifted out with the engine hood left on the machine.
821 Engine hood, removing
See:
3. Remove the front and rear underbody skid plates.
Figure 1
Underbody skid plates
Function Group:
210
Information Type:
Service Information
Service Information
Date:
2014/8/27