Installation On The Counter; Accessories - La Marzocco kb90 Series Manual

1) Installation on the counter

The image below shows the recommended method to drill the hole on the counter.
135 mm
5,3 in.
160 mm
6,3 in.
217 mm
8,5 in.
POSITION OF THE HIGH LEGS MACHINE
Fig. 4 - Hole on the Counter
HERE THE POSITION OF THE POWER CORD AND
WATER INLET HOSES
HERE THE POSITION WHERE WE
FROM ∅100 TO ∅120 mm
SUGGEST TO MAKE THE HOLE
FROM ∅4 in. TO ∅4,7 in.
HERE THE POSITION
OF THE DRAIN TUBE
565mm (2 groups) 805 mm (3 groups)
31,7 in. (3 groups)
22,2 in. (2 groups)

2) Accessories

Check the package to make sure that the
following accessories are included:
• a number of 1-dose and 2-dose portafilters
orresponding to the number of groups;
• replacement 1-dose and 2-dose filters
(one of each);
• 1 tamper;
ON THE TABLE • 1 blind filter;
• cleaning detergent, for the groups;
• 3 stainless steel braided hoses for water
connections;
• 1,5 mt of reinforced plastic tubing for
drainage;
• 1 hose clamp.
In order to proceed with installation, it is
necessary that the following are available:
• Pipes carrying drinking water with a
3/8"G (BSP) end connection; (3/8"
Compression for USA and Canada)
• Electrical Supply according to the
specification of the espresso machine
purchased:
• Single/Three phase 220VAC - 50/60
Hz electrical connection with ground,
55 mm protected socket and approved interlock
2,2 in.
switch
• Single phase 200VAC - 50/60 Hz
electrical
protected socket and approved interlock
switch
connection with ground,
13