Door Reversibility - Zanussi ZFC 67/14 Instruction Booklet

Door reversibility

Before carrying out any work on the appliance,
unplug it from the power socket.
Remove the upper hinge (Fig. 5) and slide the top
door off the middle hinge.
Remove the middle hinge, turn it through 180 and
refit it on the opposite side (Fig. 6) after having
removed the plugs (F-Fig. 7) which mask the holes.
The plugs must be refitted in the holes left open on
the opposite side.
Refit the top door and the top hinge. Unscrew the
left-hand levelling foot, which will be refitted on the
opposite side. Unscrew the right-hand levelling foot
(H), the corresponding hinge (I) and the stop (L)
and refit all these on the left-hand side (Fig. 8).
Reverse the handles after having removed the clip-
in screw covers (Fig. 9). The unused holes are
masked with plastic plugs which should be removed
and refitted in the holes left open.
Attention
After completion of the door reversibility operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdrier.
D185
6
Fig. 5
E
D045
F
D047
L
I
H
D537
D336
Fig. 6
Fig. 7
Fig. 8
Fig. 9