Conservation; Installation; Positioning; Before Using - Zanussi ZFC 67/14 Instruction Booklet

Zanussi instruction booklet refrigerator- freezer zfc 67/14
Table of Contents

Advertisement

CONSERVATION

In the interests of the Environment:
When disposing of your old fridge, freezer or fridge/
freezer.
Help to keep your country tidy – use authorised
disposal sites for your old appliances.

INSTALLATION

Warning
IF YOU ARE DISCARDING AN OLD
APPLIANCE THAT HAS A LOCK OR CATCH
ON THE DOOR, YOU MUST ENSURE THAT IT
IS MADE UNUSABLE TO PREVENT YOUNG
CHILDREN BEING TRAPPED INSIDE.
Depending upon the position you choose for your
appliance, you may wish to reverse the way in which
the door opens. To do this, refer to instructions on
"Door reversal directions" paragraph.

Positioning

This appliance is designed to operate in ambient
temperatures between 10 C (50 F) and 32 C (90 F).
It should be located in a dry atmosphere, out of direct
sunlight and away from extreme temperature e.g.
not next to a cooker or other sources of direct heat,
or in a very cold room e.g. an outhouse, where the
temperatures may fall below 10 C (50 F). If these
temperatures are exceeded i.e. colder or warmer,
then the appliance may not operate correctly.
You should also ensure that air can circulate freely
around the back and the top of the cabinet. There must
also be at least 100 mm (4") distance between the top of
the cabinet and any overhanging kitchen furniture
(Fig. 1-A). Ideally, the appliance should not be
positioned beneath overhanging furniture (Fig. 1-B).
A
B
NP003
There should also be a gap of 25 mm either side of
the appliance. Do not obstruct the space
underneath. The back of the cabinet may be placed
close to the wall but must not touch it. DO NOT
4
Fig. 1
For maximum efficiency:
Make sure that the appliance is cleaned properly.
Make sure that the door is closed properly.
Do not position the appliance near to sources of heat.
Do not over-fill your appliance, air MUST be
allowed to circulate.
install in places with restricted ventilation.
Adjust the level of the appliance by screwing out
the adjustable foot, or feet, at the bottom of the
cabinet using your fingers or a spanner (see Fig. 2).
D200

Before using

Remove all securing tapes. Wash inside the
appliance with lukewarm water and a little
bicarbonate of soda (one teaspoonful to one quart of
water). Do not use soap or detergent as the smell
might linger. Dry thoroughly.

Rear spacers

In the plastic envelope containing the Operating
Instructions are also included two wall spacers to be
fitted into the special openings provided on the back
of the appliance.
Push-fit the spacers into the openings, making sure
the arrow (A) is positioned as per Fig. 3 and then
turn the spacers through 45 until they lock in
(arrow (A) in a vertical position).
A
45°
D039
Fig. 2
Fig. 3

Advertisement

Table of Contents
loading

Table of Contents