Installation; Positioning; Before Using; Rear Spacers - Zanussi ZFC 66/14 Instruction Booklet

Zanussi instruction booklet refrigerator- freezer zfc 66/14
Table of Contents

Advertisement

INSTALLATION

Warning
IF YOU ARE DISCARDING AN OLD
APPLIANCE THAT HAS A LOCK OR CATCH
ON THE DOOR, YOU MUST ENSURE THAT IT
IS MADE UNUSABLE TO PREVENT YOUNG
CHILDREN BEING TRAPPED INSIDE.
Depending upon the position you choose for your
appliance, you may wish to reverse the way in which
the door opens. To do this, refer to instructions on
"Door reversal directions" paragraph.

Positioning

For this appliance to work efficiently, it should be
located away from heat sources, e.g. cookers,
radiators, boilers, direct sunlight etc. This also
includes locations or rooms where the ambient
temperature reaches above 32 degrees C or drops
below 10 degrees (e.g. conservatories).
You should also ensure that air can circulate freely
around the back and the top of the cabinet. There
must also be at least 100 mm (4") distance between
the top of the cabinet and any overhanging kitchen
furniture (Fig. 1-A). Ideally, the appliance should
not be positioned beneath overhanging furniture
(Fig. 1-B).
A
B
D042
There should also be a gap of 25 mm either side of
the appliance. Do not obstruct the space
underneath. The back of the cabinet may be placed
close to the wall but must not touch it. DO NOT
install in places with restricted ventilation.
Fig. 1
Adjust the level of the appliance by screwing out
the adjustable foot, or feet, at the bottom of the
cabinet using your fingers or a spanner (see Fig. 2).
D200

Before using

Remove all securing tapes. Wash inside the
appliance with lukewarm water and a little
bicarbonate of soda (one teaspoonful to one quart of
water). Do not use soap or detergent as the smell
might linger. Dry thoroughly.

Rear spacers

In the plastic envelope containing the Operating
Instructions are also included two wall spacers to be
fitted into the special openings provided on the back
of the appliance.
Push-fit the spacers into the openings, making sure
the arrow (A) is positioned as per Fig. 3 and then
turn the spacers through 45 until they lock in
(arrow (A) in a vertical position).
A
45°
D039
Fig. 2
Fig. 3
5

Advertisement

Table of Contents
loading

Table of Contents