Casio fx-9750G Operation, Service Manual & Parts List page 6

Replacing Batteries
Precautions:
Incorrectly using batteries can cause them to burst or leak, possibly damaging the interior of the unit. Note
the following precautions:
• Be sure that the positive (+) and negative (–) poles of each battery are
facing in the proper directions.
• Never mix batteries of different types.
• Never mix old batteries and new ones.
• Never leave dead batteries in the battery compartment.
• Remove the batteries if you do not plan to use the unit for long periods.
• Never try to recharge the batteries supplied with the unit.
• Do not expose batteries to direct heat, let them become shorted, or try
to take them apart.
(Should a battery leak, clean out the battery compartment of the unit
immediately, taking care to avoid letting the battery fluid come into direct contact with your skin.)
Keep batteries out of the reach of small children. If swallowed, consult with a physician immediately.
• To replace the main power supply batteries
* Never remove the main power supply and the memory back up batteries from the unit at the same time.
* Never replace the main power supply battery compartment cover or switch the calculator on while the
main power supply batteries are removed from the calculator or not loaded correctly. Doing so can cause
memory data to be deleted and malfunction of the calculator. If mishandling of batteries causes such
problems, correctly load batteries and then perform the RESET operation to resume normal operation.
* Be sure to replace all four batteries with new ones.
1. Press to turn the calculator off.
SHIFT OFF
Warning!
Be sure to switch the unit off before replacing batteries. Replacing batteries with power on will cause data
in memory to be deleted.
2. Making sure that you do not accidently press the
the calculator over.
3. Remove the back cover from the calculator by pressing it in the direction indicated
by arrow 1, and then sliding it in the direction indicated by arrow 2.
4. Remove the four old batteries.
5. Load a new set of four batteries, making sure that their positive (+) and negative
(–) ends are facing in the proper directions.
6. Replace the back cover.
7. Turn the calculator front side up and slide off its case. Next, press
power.
• Power supplied by memory back up battery while the main power supply
batteries are removed for replacement retains memory contents.
• Do not leave the unit without main power supply batteries loaded for long
periods. Doing so can cause deletion of data stored in memory.
• If the figures on the display appear too light and hard to see after you turn on
power, adjust the contrast.
key, slide the case onto the calculator and then turn
AC/ON
to turn on
AC/ON
— 6 —
1
2