Error Message List - Zoom PodTrak P4 Operation Manual

Error message list

This is a list of error messages that could pop up on the display. Respond as described below when
necessary.
Pop-up message
Read Only!
Choose 16-bit or 24-bit File!
Choose Mono or Stereo File!
Choose 44.1kHz or 48kHz File!
Choose WAV or MP3 File!
File Convert. 48kHz->44.1kHz
File Convert. 24-bit->16-bit
File Convert. MP3->WAV
Invalid File!
Card Full!
File Name Already Exists!
Input File Name!
Character Limit Reached!
Card Error!
No Card!
Invalid Card!
Card Protected!
Low Battery!
Date/Time Reset!
The file is set to be read only.
Use a computer to unlock the read only status of the file.
Select a file that is 16-bit or 24-bit.
P4
The does not support playback or conversion of the file.
Select a mono or stereo file.
The P4 does not support playback or conversion of the file.
Select a file that has a 44.1 kHz or 48 kHz sample rate.
The P4 does not support playback or conversion of the file.
Select a file that uses WAV or MP3 format.
The P4 does not support playback or conversion of the file.
This file requires sample rate conversion.
Convert to a file that is supported by the
This file requires bit rate conversion.
Convert to a file that is supported by the
This file requires file format conversion.
Convert to a file that is supported by the
This file is damaged or invalid.
Select a good file.
The SD card has no more open space.
Delete unnecessary files (
SD card.
A file with the same name already exists.
Change the file name. (
29)
Input the file name.
Input the file name. (
The maximum number of characters has been exceeded.
Reduce the number of characters.
An error occurred with the SD card.
See "Troubleshooting" on page
No SD card is loaded.
Load an SD card.
The SD card is invalid.
Load an SD card that is supported by the
54)
SD card write-protection is enabled.
Disable write-protection.
The remaining battery charge has become low.
Install new batteries or supply power by connecting an AC adapter, mobile
battery or computer, for example. (
The date and time setting has been reset.
Set the date and time again. (
Explanation
P4
P4
P4
"Deleting files" on page
"Changing the names of recorded files" on page
"Changing the names of recorded files" on page
54.
P4
"Providing power" on page
"Modifying the date and time" on page
52
.
.
.
30), or use a different
. ( "Troubleshooting" on page
15)
29)
41)