Water Tank - Beko DCU 9330 User Manual

6.2 Sensor
There are humidity sensors in your dryer that
detect whether the laundry is dry or not.
To clean the sensor:
1. Open the loading door of the dryer.
2. Allow the machine to cool down if drying
has been carried out.
3. Wipe the metal sensors with a soft cloth,
dampened with vinegar and dry them.
C
Clean metal sensors 4 times a year.
A
Never use solvents, cleaning
agents or similar substances when
cleaning since these materials can
cause fire and explosion!
Dryer / User Manual

6.3 Water tank;

The moisture in the damp laundry is taken
from the laundry and condens ed. Drain the
water tank after each drying cycle or during
drying when "Water tank" warning light turns
on.
A
Condensed water is not drinkable!
A
Never take out the water tank
when the programme is running!
If you forget to drain the water tank, your
dryer will stop during the following drying
cycles when the water tank is full and the
"Water tank" warning light will turn on. If this
is the case, press the "Start/Pause/Cancel"
button to resume the drying cycle after
draining the water tank.
*To drain the water tank:
1-Pull the drawer and remove the water tank
carefully.
2-Drain the water in the tank
3-If there is lint accumulation in the funnel
of the water tank, clean it under running
water.
4-Place the water tank into its seat.
25 / EN