Appropriate Installation Location; Removing The Transportation Safety Assembly; Connecting To The Drain - Beko DCU 9330 User Manual

3 Installation
Refer to the nearest Authorised Service Agent
for installation of your product.
C
Preparation of location and electri-
cal installation for the product is
under customer's responsibility.
B
Installation and electrical connec-
tions must be carried out by a quali-
fied personnel.
A
Prior to installation, visually check
if the product has any defects on
it. If so, do not have it installed.
Damaged products will cause risks
for your safety.
3.1 Appropriate installation
location
• Install the product in an environment
which has no risk of freezing and is in a
stable and level position.
• Operate your product in a well ventilated,
dust-free environment.
• Do not block the air ducts in front of and
under the product with materials such as
long pile rugs and wooden bands.
• Do not place your product on a long pile rug
or on similar surfaces.
• Do not install the product behind a door
with a lock, sliding door or a hinged door
which can strike the product.
• Once the product is installed, it should stay
at the same place where its connections
have been made. When installing the
product, make sure that the rear wall of
it does not touch anywhere (tap, socket,
etc.) and also pay attention to install
the product at a place where it will stay
permanently.
B
Do not place the product on top of
the power cable.
• Keep at least 1.5 cm distance to walls of
other furniture.
12 / EN
3.2 Removing the
transportation safety assembly
A
Remove the transportation safety
assembly before using the product
for the first time.
1. Open the loading door.
2. There is a nylon bag inside the drum that
contains a piece of styrofoam. Hold it from
its section marked with XX.
3. Pull the nylon towards yourself and remove
the transportation safety assembly.
A
Make sure that you have removed
the transportation safety assembly
(nylon+styrofoam pieces) before
using the product for the first time.
Do not leave any items inside the
drum.
3.3 Under counter installation
• A special part (Part no. 297 360 0100)
replacing the top trim must be provided
and installed by the Authorised Service
Agent in order to use the machine under a
counter or in a cupboard. It should never be
operated without the top trim.
• Leave at least 3 cm of space between the
side and rear walls of the product and
the walls of the counter/cupboard when
installing your product under a counter or
in a cupboard.

3.3 Connecting to the drain

In products equipped with condenser unit,
water accumulates in the water tank during
the drying cycle. You should drain accumu-
lated water after each drying cycle.
You can directly drain accumulated water
through the water drain hose supplied with
the product instead of periodically draining
the water collected in the water tank.
Dryer / User Manual