Range Road RR400 Series Owner's Manual page 12

RR400 Series
Install the 4-16mm bolts holding engine mount
plate to chipper body, snug the bolts up –Do Not
Tighten Them
Tighten the belt adjustment bolts. Adjust each
bolt ¼ turn at a time until you have less than 1" of
deflection on the belts.
Tightening these bolts actually moves the whole
engine away from the bottom pulley on the machine,
thus increasing the distance between the two pulleys
and putting more tension on the belts
Now tighten the 4-16mm bolts holding the engine
plate
Re-install the 2-13mm bolts in the inner belt
cover, center the cover over the pulleys and
tighten the bolts
Re-install the 4-13mm bolts in the belt cover
Range Road Enterprises Ltd
Page 12
Box 944
Eckville AB T0M 0X0
www.range-road.ca