Putting The Neuronode In Standby Mode; Resuming A Neuronode Session; Saving The Neuronode Settings - Control Bionics NeuroNode 3 User Manual

PAGE 26 | TROUBLESHOOTING

Putting the NeuroNode in Standby Mode

At times it will be helpful to end a current NeuroNode session in order to resume
at a later time. In order to ensure this does not disrupt the user's connection,
select the Standby Button from the NeuroNode Controller Applicaton Main
Menu.
Alternatively, follow steps 1-2 listed in the Power Cycle Guide to put the
NeuroNode in standby mode.

Resuming a NeuroNode Session

In order to resume a NeuroNode session and remove the device from Standby
mode, gently shake the NeuroNode and it will transition out of Standby, allowing
the NeuroNode to be connected in the Application.
Optionally, use the provided push pin tool to breifly push the Standby button on
the bottom of the device. The initial launch sequence should begin, indicating
an activated NeuroNode
Standby Button