Failure Codes - Samsung C61R1AAMST Service Manual

4-2 Failure Codes

4-2-1 Temp Sensor Error
Error Code
Top Sensor Open Error (Sensor-Top)
It occurs due to a defective sensor, misplaced wires, a defective PCB and
when A/D value that MICOM senses rises over 252.
Also, it may occur when the ambient temperature falls under -10˚C.
Top Sensor Short Error (Sensor-Top)
It occurs due to a defective sensor, misplaced wires, a defective PCB and
when A/D value that MICOM senses falls under 10.
IGBT Sensor Open Error (Assy-Inverter Module)
It occurs due to a defective sensor, misplaced wires, a defective PCB and
when A/D value that MICOM senses rises over 239.
Also, it may occur when the ambient temperature falls under -10˚C.
IGBT Sensor Short Error (Assy-Inverter Module)
It occurs due to a defective sensor, misplaced wires, a defective PCB and
when A/D value that MICOM senses falls under 10.
4-2-2 Safety Error
Error Code Gerneral Function
Touch Button Short
Error
Low Voltage Error
Over Temperature Error It occurs when the temperature of the Top Sensor rises
Pan Detection Error
DC Motor Locking Error
Solution
It occurs when the control panel's sensor field is shorted
more than 10 seconds.
ex: No.1 Place a damp cloth on the control panel.
No.2 Liquid boils over and lands on the control panel.
No.3 More than one key is pressed more than
10 seconds.
No.4 Defective Assy-Touch PCB
It occurs when the DC 12V is dropped under 9V.
It may occurs due to defects of PCB or wiring.
very highly.
(Estimated temperature of ceramic glass's surface is
more than 250˚C.)
ex: Place a empty cookware on the burner and operate the
hob.
It occurs when the cookware is unsuitable or too small or
no cookware has been placed on the cooking zone.
If the suitable cookware is placed again, the hob will oper-
ate normally.
It occurs when the DC Motor cannot operate due to defects
of PCB, wiring or some disturbance on motor blade.
- 15 -
Solution
Page
16 Page
17 Page
18 Page
19 Page
Page
20 Page
21 Page
22 Page
23 Page
24 Page