Kubota M7131 Operator's Manual page 200

168 HYDRAULIC UNIT
BFlow Control Valve
To avoid the possibility of personal injury or death
be aware of the
adjustments:
A The 3-point hitch operation is influenced by the
combination of the adjustment of the flow
control valve and the engine speed.
A The 3-point hitch may rise slowly or not at all at
low engine rpm.
A The 3-point hitch may rise suddenly if engine
rpm is increased, or, flow control adjustment is
changed.
(1) Remote control valve with flow control
(2) Remote control valve with flow control
(3) Flow control knob for valve (1)
(4) Flow control knob for valve (2)
C Adjusting the flow rate
1. The flow rate for the remote control valve can be
adjusted.
2. Turn the flow control knob counterclockwise (+), and
the flow rate for the remote control valve increases. A
clockwise turn (-) of the knob causes the flow to
decrease. If the knob is turned all the way (C), there
will be no flow.
3. To adjust the flow rate, set the engine speed to the
operating rpm, turn the flow control knob once all the
way clockwise (C), and then turn it gradually
counterclockwise until the required flow rate is
reached.
A When there is no need to adjust the flow rate, turn the
flow control knob all the way counterclockwise and
keep it in this position.
following when making
(1) Remote control valve with flow control
(2) Flow control knob for valve
BRemote Control Valve Lever
The remote control valve lever directs pressurized oil flow
to the implement hydraulic system.
Each lever can be switched among its 4 positions.
Set the lever to the FLOAT position, and the lever is kept
at that position.
(1) Remote control valve lever
(+) "INCREASE"
(-) "DECREASE"
(C) "STOP"
(A) "EXTEND"
(B) "RETRACT"
(N) "NEUTRAL"
(C) "FLOAT"