Table of Contents
Advertisement
WBT – Standard
A
: Transducer: Channel 1 - 2
P1
: Transducer: Channel 3 - 4
B
P2
WBT – High power
: Transducer: Channel 1 - 2
A
P1
Procedure
1
Pull the transducer cable through the steel conduit.
2
Make sure that an ample length of the transducer cable is available for maintenance
and replacement.
3
Cut the transducer cable.
4
Find the panel for the rear side of the WBT, the cable glands, the blind plugs and
the nuts.
417772/A
Cable layout and interconnections
23
Advertisement
Table of Contents
