Assembly And Adjustments; Operation - DeWalt DW630 Original Instructions Manual

If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organization.
E
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data).
The minimum conductor size is 1.5 mm
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Mounting and Removing the Sanding
Disc (fi g. B, D)
1. Press the backing pad (6) onto the spindle (5).
2. Fit the sanding disc (7) correctly onto the
backing pad.
3. Screw the threaded flange (8) onto the spindle
(5).
4. Press the spindle lock (4) and rotate the pad
until it locks in position.
5. Tighten the threaded flange using the two-pin
spanner (10) supplied.
6. Release the spindle lock.
7. To remove the sanding disc and backing pad,
loosen the threaded flange using the two-pin
spanner (while the spindle lock is engaged.)
Mounting and Removing the
Polishing Bonnet (fi g. C, D)
1. Press the backing pad (6) onto the spindle (5).
2. Screw the threaded flange (8) onto the spindle
(5).
3. Press the spindle lock (4) and rotate the pad
until it locks in position.
4. Tighten the threaded flange using the two-pin
spanner (10) supplied.
5. Release the spindle lock.
6. Pull the polishing bonnet (9) over the backing
pad and pull the strings tight. Make a tight knot
and securely push the strings and knot under
the polishing bonnet.
WARNING: Make sure that the strings
are covered completely under the
polishing bonnet.
7. To remove the polishing bonnet, loosen the knot
and pull the bonnet off the backing pad
8. To remove the backing pad, loosen the
.
2 threaded flange using the two-pin spanner
(while the spindle lock is engaged.)
Mounting the Side Handle (fi g. E)
Screw the side handle (3) tightly into one of the holes
(11) on either side of the gear case with the guard in
position to provide optimum screening.
Prior to Operation
Install the appropriate accessory. Do not use
excessively worn accessories.

OPERATION

Instructions for Use
WARNING:
• Always observe the safety instructions
• Ensure all materials to be sanded or
• Apply only a gentle pressure to the
• Avoid overloading. Should the tool
EN GL IS H
and applicable regulations.
polished are secured in place.
tool. Do not exert pressure on the
sanding or polishing accessory.
become hot, let it run a few minutes
under no load condition.
27