Troubleshooting Guide - Toro TBC WP User's Manual And Installation Instructions

Troubleshooting Guide

The following problem samples are listed to help you troubleshoot your TBC
case you encounter performance issues.
Many of the problems involving the TBC
transmission/reception. These are usually caused by low battery power or improper battery
connection. Other causes can also be improper wire connections or a dirty IR connector.
Problem:
Possible Cause:
Solution:
Possible Cause:
Solution:
Possible Cause:
Solution:
Possible Cause:
Solution:
Possible Cause:
Solution:
Possible Cause:
Solution:
TM
Faulty Transmission
Low battery power
Replace the batteries
Improper battery connection
Verify that the batteries are connected properly
The TBC WP controller IR port is dirty
TM
Clean the TBC WP IR port
TM
Improper connection between hand held and controller
Reconnect the IR port and verify that connection is secure
The TBC WP microprocessor did not properly reset
TM
Reset the controller by removing the batteries from the controller.
Ground both battery lead terminals for 1-minute. Reinstall the batteries.
If using the integrated radio, the controller and hand held identification
codes do not match.
Reset the controller by removing the batteries from the controller. Ground
both battery lead terminals for 1-minute. Follow the controller setup in
the TBC HH User's Guide.
TM
WP controller are commonly associated with
WP controller in
TM
9