Before Using; Battery Installation; Power On - Polaris Karat Flash Meter Instruction Manual

Before Using

２．
2-1

Battery Installation

The meter is powerd by two AA alkaline batteries.
○ Remove the Battery Compartment⓱ cover by lightly pressing the
ridged area and sliding the cover in the direction indicated by the
arrow.
○ Insert new batteries into to the Battery Compartment⓱ following
the polarity symbols.
○ Replace the Battery Compartment⓱ cover
*If the meter will not be used for an extended period of time, it is recommended
to remove the batteries to avoid possible damage caused by battery leaking.
2-2

Power ON

Press the Power Button❸ and turn the power on.
The Power Indicator Light❹ will light up, and the
"MENU" will display on the LCD screen. 【See 2-3】
*To turn off, press and hold the Power Button❸ for a few seconds.
*The next time the unit is turned on, the last mode used will be displayed.
ASPEN CORPORATION
→Full battery power remaining
→Sufficient battery power remaining
→Low battery power remaining
→Replace battery immediately
(※Metering not affected by low batteries.)
4