Table of Contents
Advertisement
2-9
Program Level (PL) Setup
The Program Level feature allows you to pre-set the meter to your preferred exposure readings. By
adjusting the Program Level, the meter will automatically adjust readings to overexpose or underexpose
by as little as a tenth of an Aperture (F) or as much as 9/10 of Aperture (F).
1)
On "MENU" screen, press the Cross Key⓬ to move the cursor to select
"SET". Press the Select Button⓭.
2)
On "SETTING" screen, press the Cross Key⓬ to move the cursor to select
"Program Level". Press the Select Button⓭. 【See Pic. 1】
3)
Cursor is moved to a number by pressing Select Button⓭, and then the
correction value is set using the Cross Key ⓬ (Up △ / Down ▽ ).
【See Pic. 2】
4)
Press the Cross Key⓬ (Up △ ) to increase values by 0.1 steps to <under
exposusre>, press the Cross Key⓬ (Down ▽) to decrease values by 0.1 steps to <over exposure>.
5)
Press and hold the Cross Key⓬ (Up △ / Down ▽) for more than one second, the value will change
continuously.
ASPEN CORPORATION
【Pic. 1】
10
Advertisement
Table of Contents
