Table of Contents
Advertisement
3-5
Flash Measurement：Shutter Speed (T) Priority Mode
◎With synch cord
1)
Select
【See 2-3】
2)
Check and set the ISO value. 【See 2-5】
3)
Set the Shutter Speed (T). 【See 2-7】
4)
Connect the synch code from the flash unit to the meter's Synch Port⓯.
5)
Press the Measuring Button⓫ to fire the flash and measure the Aperture (F).
＊Press the Measuring Button⓫ again, the flash fires again and the meter takes a new reading.
6)
Measured Apterture (F) value is displayed.
7)
In addition, the ratio of the flash to the total amount of light is displayed as a percentage (in 1%
increments) in Flash Ratio (FR) Window.
◎Without synch code
1)
Select
【See 2-3】
2)
Check and set the ISO value. 【See 2-5】
3)
Set the Shutter Speed (T). 【See 2-7】
4)
Press the Measuring Button⓫."Waiting" is displayed, and then meter is ready to take a reading.
ASPEN CORPORATION
on MENU display, and press the Select Button⓭.
on MENU display, and press the Select Button⓭.
15
Advertisement
Table of Contents
