Table of Contents
Advertisement
INTRODUCTION
Note:
Vapours from the oven vents may in time
cause discoloration of wall coverings behind the
appliance. For ease of cleaning it may be preferable
to tile behind the appliance.
Overhanging surfaces or a cooker hood should be a
minimum of 685mm above the hob.
It is important to ensure that the appliance is level
after installation.
Levelling feet are fitted to the
appliance to accommodate uneven floors.
GENERAL NOTES ON USING THE
OVEN
We suggest that you run the oven elements for 10 –
15 minutes at 220°C to burn off any residue from
their surfaces.
The procedure should be repeated with the grill for
approximately 5 –10 minutes.
During this period an odour may be emitted, it is
therefore advisable to open a window for ventilation.
ABOUT CONDENSATION AND STEAM
When food is heated it produces steam similar to a
boiling kettle. The ovens are vented to allow some of
the steam to escape. However, always stand back
from the appliance when opening the oven door to
allow any build up of steam or heat to release.
If the steam comes into contact with a cool surface
on the outside of the appliance, e.g. a trim, it will
condense and produce water droplets. This is quite
normal and is not caused by a fault on the appliance.
To prevent discolouration, regularly wipe away
condensation
and
also
including the air vent at the rear of the hob.
For your safety wallcoverings at the rear of the
appliance should be securely fixed to the wall.
soilage
from
surfaces
THE COOLING FAN FOR THE CONTROLS
The cooling fan operates immediately when the grill
or top oven is switched on. It may run on after the
controls are switched off until the appliance has
cooled.
The cooling fan may operate after a time when the
fan oven is in use.
temperature setting and the length of time the oven
has been in use.
CONTROL PANEL INDICATOR NEONS
These lights indicate whether the ovens are switched
ON.
The neons also indicate when the set temperature
has been reached. They will turn on and off during
use to show that the temperature is
maintained.
If the neons do not operate as the instructions
indicate the controls have been incorrectly set.
Return all controls to zero and reset following the
instructions for the required setting.
COOKWARE
Baking trays, oven dishes etc., should not be placed
directly against the grid covering the fan at the back
of the oven.
Do not use baking trays larger than 30cm x 35cm
(12" x 14") as they will restrict the circulation of heat
and may affect performance.
9
This will depend on the
being
- Quick Links:
- Condensation and Steam
Hide quick links:
Advertisement
Table of Contents
