Page 1
VIGO INDUSTRIES INSTALLATION GUIDE FOR SHOWER ENCLOSURE (MODEL VG06051) SAFETY PRECAUTIONS This Installation Guide uses the following symbols to indicate important information. Always observe the instructions indicated by these symbols. WARNING Instructions that, if ignored, could result in death or serious personal injury caused by incorrect handling or installation of the product.
Apply a bead of silicone between the walls and base of the stall. • For optimum performance, you should install the shower door perfectly level on a level surface. MODEL VG06051 HAS A REVERSIBLE DOOR AND CAN THEREFORE BE INSTALLED TO EITHER THE RIGHT OR LEFT SIDE (SEE CONFIGURATION DIAGRAM BELOW)
Page 5
5. Place the structural rail (#14) inside the wall mount bracket (#1). [SEE FIG.4 & FIG.5] 6. Place the structural rail screw (#15) into the side glass panel and screw together with the structural rail. MODEL VG06051...
Page 6
13. Place the side glass panel and the structural rail back to the shower opening. 14. Screw the side glass support to the wall with 2” screw (#20). 15. Tighten the hex screw on the wall mount bracket body and the structural rail screw. [SEE FIG.4] MODEL VG06051...
Page 7
10. Align the big front fixed panel to the shower opening location. 11. Screw the big front fixed panel to the structural rail with the fixed panel holders (FIG.6). 12. Screw the big front fixed panel to the bottom clip. MODEL VG06051...
Page 8
1. Seal the end cup bottoms with clear silicone caulk. 2. Seal the threshold bottom with clear silicone caulk. 3. Slide the end cups to the small front fixed panel (#5) and big front fixed panel (#4). Align the threshold with the glass. MODEL VG06051...
(#21) inside them. 6. Screw the door guide to the floor with 1-1/8” screws (#19). 7. Place the door back on the structural rail. Screw the bottom rollers (#3) to the door. MODEL VG06051...
Page 10
[SEE FIG.14] 2. Apply silicone caulk along the fixed panel and the threshold of the shower enclosure interior. IMPORTANT • WAIT 24 HOURS BEFORE USING SHOWER. • DO NOT ALLOW WATER TO DIRECTLY HIT DOOR SEAL STRIP. MODEL VG06051...
Page 11
• Do NOT use abrasive cleaners, scrapers, metal brushes, or any items/products that would scratch and/or dull surface. • Do NOT allow surface to come into contact with acetone (nail polish remover), dry cleaning solution, lacquer thinner, gasoline, or any other similar product. MODEL VG06051...
VIGO warrants faucets to be free from defects in workmanship and materials under normal use and service for a period of one (1) years from the initial date of purchase by the owner or end-user, contractor, or builder, from an authorized dealer.
Need help?
Do you have a question about the VG06051 and is the answer not in the manual?
Questions and answers