WolfPack HDTVHDVE100 Quick Start Manual

Ir setup for hdmi over cat5

FREE CONSULTATION: Call For Advice To Solve Your AV Needs

This document will work with either of the 2 products listed below:-

HDMI over 1 - CAT5 cable to 100' w/Remote IR HDTV-E50A

http://www.hdtvsupply.com/hdmi-over-1-cat5-cable.html

HDMI Over Cat5 Transmitter & Receiver to 300' w/Remote IR HDTVHDVE100

http://www.hdtvsupply.com/hdmi-over-cat5.html

Here are the steps to get the HDMI Over CAT5/6/7 Cable connected and IR to function.

Before installing the CAT5/6/7 cable in to a wall, connect the CAT cable between the Transmitter and

Receiver on the floor.

2. Connect one HDMI cable from the source to the transmitter

3. Connect one HDMI cable from your receiver to your TV

4. Plug in the power supplies to both the transmitter and receiver

5. Now that you have a picture you can install the CAT5/6/7 cable in the wall ceiling or wherever you are

wanting to run it

1. On the transmitter side connect the IR cable that looks like the picture below to the IR OUT

2. Now find the IR emitter on your source device we like to take a flashlight and point it at the front panel of the

source like below.

HDTVSupply.com

Free Lifetime Live Tech Support - 800-841-9238

IR setup for HDMI over CAT5

www.hdtvsupply.com

Table of Contents

Do you have a question about the HDTVHDVE100 and is the answer not in the manual?

Page 1 HDMI over 1 - CAT5 cable to 100' w/Remote IR HDTV-E50A http://www.hdtvsupply.com/hdmi-over-1-cat5-cable.html HDMI Over Cat5 Transmitter & Receiver to 300' w/Remote IR HDTVHDVE100 http://www.hdtvsupply.com/hdmi-over-cat5.html Here are the steps to get the HDMI Over CAT5/6/7 Cable connected and IR to function.
Page 2 3. Using the included sticky tape attach the IR to the source device 4. On the receiver side connect the IR cable that looks like the picture below to the IR IN 5. Now connect the IR to your TV an example has been included 6.

Hdtv-e50a