Related Manuals for WolfPack HDTVHDES02-5
Summary of Contents for WolfPack HDTVHDES02-5
- Page 1 USER MANUAL 120m HDMI Matrix Extender over IP (Support multipoint to multipoint, IR control, 1080P)
- Page 2 1.Introduction 120m HDMI Matrix Extender over IP is a device based on the standard TCP/IP protocol for transmitting HD audio and video source over LAN . It transmits your HD display with the high resolutions up to 120 meters away from your HDMI or DVI-D source by using one CAT5e/6 cable. At the same time, it’s also convenient to transmit HDMI audio and video source by point-to-point, multipoint-to-multipoint and cascade connection mode. 2.Features & Specifications Ø Support HDMI1.3/HDCP1.1&1.2 Ø Support point-to-point mode, multipoint-to-multipoint mode and cascade connection mode. Ø Standard 802.3 Ethernet Ø Support one way IR extension. Ø Pure hardware design, plug and play, do not need to install additional software HDTV Resolutions 480p,720p,1080p Audio Sample rate:32kHz,44.1kHz,48kHz IR remote control 38kHz;NEC HDMI HDMI 1.3...
- Page 3 HDCP HDCP 1.2 Power adapter DC5V/1A Power consumption HDMI Sender:3W HDMI receiver:3W Size(L-W-H) 92x79x28mm Weight 240g x 2 Operating Temperature/Humidity 0℃-70℃/10%-80%RH(no condensation) Storage Temperature/Humidity -10℃-80℃/5%-90%RH(no condensation) 3.Package Contents Before attempting to use this unit, please check the packaging and make sure the following items are contained in the shipping carton: 1) one piece of HDMI transmitter 2) one piece of HDMI receiver 3) Two pieces of DC 5V power supply 4) One pair of IR transmitter and receiver 5) User’s Manual 4.Physical interface diagram HDMI Transmitter...
- Page 4 Port Function DC/5V Supply power for the transmitter RESET Hold down the key,the model will re-start IR-TX Connect IR transmitter to this port HDMI IN Connect HDMI source to this port UTP OUT Cat5e/6 cable out SET Multipoint to multipoint match setting HDMI Receiver...
- Page 5 Port Function DC/5V Supply power for the receiver RESET Hold down the key,the model will re-start IR-RX Connect IR receiver to this port HDMI OUT Connect HDTV to this port UTP IN Cat5e/6 cable in SET Multipoint to multipoint match setting 5.Connection and operation 1) Connect the HDMI source to the HDMI Transmitter with HDMI cable 2) Connect the HDMI receiver to the HDTV display with HDMI cable. 3) Use one Cat5e/6 cable up to 120m to connect the Sender and Receiver. 4) Connect the “IR receiver “into “IR-TX” port on transmitter, and “IR transmitter ” into the “IR-RX” on receiver, and make sure the IR transmitter aim at IR receiver of the controlled device if you need the IR control function. 5) Connect two pieces of 5V power supply to the transmitter and receiver, power supply for the equipment and the LED indicator light on. When status lamp on and flicker, equipment starts normal.
- Page 6 6.Application diagrams Application 1: point to point application Application 2: multipoint to multipoint application Note: For multipoint to multipoint application, you’d better choose the gigabit switch with IGMP Multicast function and three layers protocol...
Need help?
Do you have a question about the HDTVHDES02-5 and is the answer not in the manual?
Questions and answers