Siemens CEREBRUS PYROTRONICS AD-3XRI Installation/Wiring Instructions page 9

Model AD-3I or AD-3ILP
SEE NOTE 3
4 3
+ +
NOT
USED
RED
TERMINAL
BLOCK
WIRE NUT
BLACK
REQUIRED
+
ZONE WIRES FROM SIEMENS
BUILDING TECHNOLOGIES, INC.
_
SYSTEM XL3 CONTROL PANEL
Typical Connections for Models AD-3XRI and AD-3XRILP when used with XL3
NOTES:
1. The relay contacts are shown just after a reset pulse, which
represents the non-alarm condition.
2. If the relay contacts are being used to control 120 VAC operated
equipment, ensure that the conduit is properly attached to the internal
INSTALLATION OF SMOKE DETECTORS
Programming
Model AD-3XRI or AD-3XRILP
2 1
_
+
OPTIONAL
REMOTE ALARM
INDICATOR
MODEL RLX-1
OR RLX-2
SEE NOTE 3
5 5 6 7 8 9 10 11
- -
+
RELAY
BOARD
ALARM CONTACTS
125 VAC/24 VDC, 3A
SEE NOTES 1 AND 2
NOT USED
Figure 6
ground strap, using the proper conduit locking nuts. Failure to
provide proper grounding may result in fatal electrical shock and
causes non-conformance with national and local codes.
3. Use DI-BX3, DI-BX3H, ID-60IB, ID-60IBH, ILI-1B, ILI-1BH, and ILP-1
detectors only.
Model AD-3XRI or AD-3XRILP
SEE NOTE 3
5 5 6 7 8 9 10
- -
+ +
ALARM CONTACTS
125 VAC/24 VDC, 3A
SEE NOTES 1 AND 2
NOT USED
TO NEXT
ADDRESSABLE
DEVICE
11
+
_