Vulcan-Hart VC5G Extended Shutdown & Restart

Following you will find instructions on how to shut down your Vulcan cooking equipment for an extended period, and
how to safely restart equipment aft er idle.
Always refer to the procedures as instructed in the Installation & Operation manual for your specific model.
Manuals may be found by visiting the Vulcan website and clicking on RESOURCES at the top right of the home page.
Always remember that cooking equipment and its parts are hot. Use care when operating, cleaning or performing
maintenance.
For additional product resources, please visit
CONVECTION OVENS
EXTENDED SHUTDOWN – ALL MODELS
1. A thorough cleaning of the oven, both interior and exterior.
a. Clean and clear the rear air intake.
b. Check exhaust vent for blockage.
c. Wipe down the interior and door glass with a damp rag.
i. Cool down oven.
ii. Remove oven racks.
iii. Lift rack guides on either side of oven off of holders. Racks and guides may
be run through dishwasher while oven cavity is being cleaned.
iv. Clean with soap and water using non-metallic scouring pad, if necessary.
If dirt and grease have accumulated, a mild ammonia solution or
commercial oven cleaner such as Easy-Off or Dow may be used.
d. Wipe down the exterior and door glass with a damp rag.
i. Cool down oven.
ii. Wipe exposed, cleanable surface when cool with a mild detergent and hot water. Dry thoroughly with a
clean cloth.
iii. Stubborn stains may be removed by using a non-metallic abrasive pad, rubbing in the direction of the
metal's grain. If necessary, for particularly heavy deposits, you may mix a thin paste of water and scouring
powder and apply it with a sponge. Be careful to apply light pressure and remember to rub only in the
direction of the grain in the metal.
iv. The control panel surface is easily cleaned with hot water, soap and a soft cloth. Do not use hard abrasives,
solvent type materials or metallic scouring pads since these will scratch or cloud the surface.
v. Never spray the perforated areas or control panel with steam or water, as this will allow moisture into the
control cavity, which could damage electrical components.
e. Maintain fan area.
i. If aluminum foil is routinely used to wrap food or cooking vessels during oven operation, the following
preventative maintenance must be performed:
1. Remove oven racks and rack guides.
2. Check blower wheel and air baffle for particles of aluminum foil or food deposits.
2. Inspect the oven for any signs of excessive wear and tear and order replacement parts (e.g. door glass assemblies, door
roller latch, burner tube and spark igniter).
3. Shut off gas supply.
4. Shut off electric supply.
5. Leave oven doors slightly open.
F44298 (04-20)
EXTENDED SHUTDOWN & RESTART OF
YOUR VULCAN COOKING EQUIPMENT
https://www.vulcanequipment.com/.
Model VC5G
Shown with optional casters
Page 1