Cleaning And Filling Ice Bin - Coca-Cola Freestyle 9100 User Manual

maintenance

cleaning and filling ice bin

Ice bin cleaning best practices
Remove ALL ice by using the ice dispense lever
(if a top mounted ice maker is installed, follow
manufacturer's recommendation for cleaning)
Unplug dispenser.
Remove ice bin lid.
Pour warm water slowly into the bin (not over
the ice chute) to melt the remaining ice on the
cold plate.
Spray approved sanitizer solution (Kay-5) onto
all internal surfaces of ice bin and both sides of
ice bin lid.
Wipe or scrub areas within reach inside the bin
with either a clean cloth or an ice bin brush
(small parts #149322). Spray approved sanitizer
solution on all internal surfaces and lid again,
allow draining and air dry.
Return to normal operation.
NOTE: For complete disassembly instructions,
contact your Coke representative.
© 2020 The Coca-Cola Company | Coca-Cola Freestyle® 9100 User Guide | Confidential information of The Coca-Cola Company | 20200821 |
How to check/fill ice
Maintaining the proper ice level is critical
to ensuring guests receive a quality
beverage. For a top-mount ice maker,
follow established procedures for checking
ice level. If you fill the ice manually, check
to ensure ice is at least 1/3 full at all times.
Fill the ice bin by following the steps
illustrated below:
Fill a clean bucket with ice.
Safely lift and remove ice bin lid.
Dump the ice in the ice bin and
fill until full. (approximately
2" from the top) DO NOT
OVERFILL
Replace ice bin lid.
Store bought or "bagged
NOTE:
ice" SHOULD NEVER BE USED as it
may seriously damage the Coca-Cola
Freestyle® 9000 dispenser ice bin.
full
2/3 full
1/3 full
Ice bin should NEVER be less
than one-third full
17