Cleaning Nozzle, Injector Ring, And Ice Chute - Coca-Cola Freestyle 9100 User Manual

maintenance

cleaning nozzle, injector ring, and ice chute

How to properly clean the nozzle and
injector ring
Locate the nozzle. Using a clean cloth to protect your
fingers, twist nozzle counter-clockwise, and then pull
down to remove.
Scrub the nozzle at a 45° angle with dish soap using an
approved nozzle brush (Coke part #149326).
Rinse nozzle in warm, clean, drinkable water.
Place nozzle in approved sanitizer solution (Kay-5).
Shake nozzle when submerging to remove any air
bubbles and soak the nozzle for a minimum of 2
minutes. CAUTION: DO NOT SOAK NOZZLES
OVERNIGHT!
Dip the pointed end of the nozzle brush (small parts
#149326) in sanitizer solution and scrub the injector ring
at a 45° angle. Focus on the small holes where
ingredient comes out and the area where the nozzle
was connected (inner ring). To access the interior
surfaces of the inner ring, use the wire handle nozzle
brush (small parts #16586). Wipe injector ring with a
clean cloth and sanitizer and allow to sit for 2 minutes.
Then repeat with fresh sanitizer solution.
Allow the nozzle and injector ring area to "AIR DRY",
then use a clean cloth to reinstall nozzle and lock into
place turning clockwise.
NOTE: Take extra care to ensure the nozzle is inserted
completely and locked into place.
14
| © 2020 The Coca-Cola Company | Coca-Cola Freestyle® 9100 User Guide | Confidential information of The Coca-Cola Company | 20200821
How to properly clean
the ice chute
Turn off power using green power button.
Use the ice chute brush (small parts
#143257) and approved sanitizer
solution (Kay-5) to clean inside the
ice chute.
Wait two minutes to allow to air
dry, then repeat step 2 with fresh
sanitizer solution.
Wipe the outside of the ice chute tip
using a clean cloth and fresh sanitizer
solution.
Allow time for the ice chute
and ice chute tip to air dry.
ice chute brush
#143257