Related Manuals for CH Hanson PALMGREN 9681061C
Summary of Contents for CH Hanson PALMGREN 9681061C
- Page 1 Operating Manual & Parts List 9681061C 2 x 6" belt and disc Sander Read carefully and follow all safety rules and operating instructions before first use of this product. 9631694.01-1117...
-
Page 2: Getting Started
Palmgren Operating Manual & Parts List 9681061C GETTING STARTED • All tools should be visually inspected before use, in addition to regular periodic maintenance inspections. • Be sure that the voltage labeled on the unit matches your power supply. STRUCTURAL REQUIREMENTS SEE GENERAL SAFETY INSTRUCTIONS, CAUTIONS AND Make sure all supporting structures and load attaching devices are WARNINGS AS SHOWN. -
Page 3: Specifications
Palmgren Operating Manual & Parts List 9681061C SAFETY RULES (CONTINUED) Disc table dimensions ........6 ⁄... -
Page 4: Installation
Palmgren Operating Manual & Parts List 9681061C ASSEMBLY (CONTINUED) ELECTRICAL CONNECTIONS WARNING: All electrical connections must be performed by a qualified electrician. Make sure tool is off and disconnected from power source while motor is mounted, connected, reconnected or ASSEMBLE BELT TABLE anytime wiring is inspected. -
Page 5: Operation
Palmgren Operating Manual & Parts List 9681061C INSTALLATION (CONTINUED) • Always wear eye protection or face shield. • Make sure abrasive belt tracks properly. Correct tracking gives optimum performance. WARNING: This work should be performed by a qualified • After turning switch on, always allow belt to come up to full electrician. -
Page 6: Maintenance
Palmgren Operating Manual & Parts List 9681061C OPERATION (CONTINUED) ABRASIVE DISC FINISHING 1. Abrasive disc sanding is well suited for finishing small end sur- faces and convex edges. 2. Move workpiece across down side (right) of face of ADJUST BELT ASSEMBLY POSITION abrasive disc. -
Page 7: Troubleshooting
Palmgren Operating Manual & Parts List 9681061C TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE(S) CORRECTIVE ACTION Motor will not start 1. Blown line fuse or tripped circuit breaker 1. If fuse is blown, replace with fuse of proper size. If breaker tripped, reset it 2. - Page 10 Palmgren Operating Manual & Parts List 9681061C NOTES...
- Page 11 Palmgren Operating Manual & Parts List 9681061C NOTES...
-
Page 12: Warranty
Palmgren Operating Manual & Parts List 9681061C WARRANTY Palmgren warrants their products to be free of defects in material or workmanship. This warranty does not cover defects due directly or indirectly to misuse, abuse, normal wear and tear, failure to properly maintain the product, heated, ground or otherwise altered, or used for a purpose other than that for which it was intended.