Veracity LONGSPAN MAX Quick Start Manual page 2

ETHERNET AND LONGSPAN MAX LEDS
| The tables below show the LED status
for the Ethernet and LONGSPAN Max
ports on the LONGSPAN Base device.
|
The green LONGSPAN Max LED may
blink quickly while connecting.
ETHERNET SIDE
+ _
Yellow
LED
ETHERNET LEDS FUNCTION
RJ45 Green
On
RJ45 Yellow
On
Flash
SAFEVIEW ™ LEDS
| SAFEVIEW™ warning and error codes
are very rarely displayed in typical
installations.
| However, they can assist you to quickly
resolve any installation issues that may
occasionally arise.
10 25 40
Blue LEDs show the POE power available for the
camera(s), or other POE-compliant device(s) in
watts. The power level is displayed after the
LONGSPAN Max Camera side unit has powered up.
10 25 40
Overload Short-circuit Signature High-temp
Overload Short-circuit Signature High-temp
Wiring Equipment
LONGSPAN MAX (BASE) DIMENSIONS
Green
LED
Power
Power Good
Link / Activity
Link Established
Network Activity
50 60
50 60
111mm
100mm
96mm
120mm
| For extremely long runs, it may take a
few seconds to optimise the link.
| For more detailed connection information
refer to the current LONGSPAN Max
datasheet on www.veracityglobal.com
LONGSPAN SIDE
Yellow
LED
LONGSPAN LEDS FUNCTION
RJ45 Green
On
Flash
Blink
RJ45 Yellow
On
Flash
|
The maximum POE power available for
connected devices is detected and
displayed automatically.
|
SAFEVIEW™ LEDs display status and
diagnostic information for both the Base
and the Camera end LONGSPAN Max
units (i.e. the information is the same at
each end).
In normal operation, the SAFEVIEW™ LEDs
display power available in flashing or steady blue.
ON = POE enabled to camera.
FLASH = POE available but not enabled,
no compliant device detected.
If the power displayed is less than your camera
or cameras require, then consider using a
local Veracity 54-57V DC PSU to power the
LONGSPAN Max device at the camera end.
If LONGSPAN MAX detects an error or fault, a
diagnostic code will flash red on SAFEVIEW™
POE power draw has exceeded limit.
Power source must be upgraded.
Voltage too low, POE disabled. Check voltage
and polarity of power supply.
POE to camera refused or disconnected due to
error as indicated.
POE over LONGSPAN MAX refused or
disconnected due to error as indicated.
POE over LONGSPAN MAX enabled but no link.
Check cable length, wiring, and equipment.
Cable wiring error / inferior equipment detected,
connection refused.
Green
LED
Power
100Mbps
10Mbps
No link
Link / Activity
Link Established
Network Activity
+ _
36mm