Notes - Sinclair ASE-150AH Service Manual

1. Notes

CAUTION:
 Transport the air conditioner with the original package.
 Do not throw the remote controller and wired controller.
 If the air conditioner needs to be installed on a metal part of the building, electric insulation must
be performed, and the installation must meet the relevant technical standards of electric devices.
 The unit must be installed 2.3m above floor and shall not be installed in the laundry.
 The enclosure of the appliance shall be marked by word, or by symbols, with the direction of fluid
flow.
 An all-pole disconnection switch having a contact separation of at least 3mm in all poles should be
connected in fixed wiring.
 Operate the remote controller within the receiving scope of the indoor unit, and direct the
transmitting part of the remote controller to the receiver of the indoor unit.
 Install the unit where enough space of installation and maintenance is available.
 Install the unit where the ceiling is horizontal and enough for bearing the weight of the indoor unit.
 Install the unit where the air inlet and outlet are not baffled and the least affected by external air.
 Install the unit where the supply air flow can be sent to all parts in the room.
 Install the unit where it is easy to lead out the connective pipe and the drain pipe.
 Install the unit where no heat is emitted from a heat source directly.
 Installing the equipment in any of the following places may lead to faults of the equipment (if that
is inevitable, consult the supplier):

The site contains mineral oils such as cutting lubricant.

Seaside where the air contains much salt.

Hot ring area where corrosive gases exist, e.g., sulfide gas.

Factories where the supply voltage fluctuates seriously.

Inside a car or cabin.
15