Connecting The Switched Devices; Powering Up The System - Black Box Pow-R-Boot 5 Manual

POW-R-BOOT 5

3.4 Connecting the Switched Devices

Now plug the power cords or the power-supply input cords of each of the
devices whose rebooting you want to control into one of the five AC outlets
on the rear panel of the Pow-R-Boot 5. Make sure that the power switches of
these devices are all turned ON. Once you plug in the PRB 5, each time you
turn it ON with its ON/OFF switch it will immediately provide AC power to
all of its outlets (see the next section).
Each of the PRB 5's AC outlets is capable of switching up to 5 amps
of AC power. The total current load on all five outlets cannot exceed
10 amps for the 115-VAC model (SWI020A) or 5.2 amps for the 230-VAC
model (SWI020AE).

3.5 Powering Up the System

If your Pow-R-Boot 5 is the 230-VAC model (SWI020AE), connect an
appropriate power cord to the IEC 320 male power inlet on its rear panel.
Now plug the PRB 5's power cord into a working AC outlet and turn ON
the PRB 5's ON/OFF switch. The PRB 5 and the devices plugged into it
should begin functioning immediately. (Any time the unit is OFF and is
turned ON, it will provide power to all five of its outlets instantly.) The
PRB 5's POWER ON LED should light.
The unit is now ready for continuous operation.
14