Rackmounting The Unit; Connecting The Master Device - Black Box Pow-R-Boot 5 Manual

POW-R-BOOT 5

3.2 Rackmounting the Unit

You can use the included screws and rackmount brackets to mount the
Pow-R-Boot 5 in any standard 19" rack. If you would rather mount the
PRB 5 in a 24" rack, call Black Box; we may be able to give you a quote
on special brackets.

3.3 Connecting the Master Device

The Control Area of the rear panels of the Pow-R-Boot 5 consists of a DB9
male connector labeled "RS232" and an RJ-11 jack labeled "CPM." Use
either of these inputs to connect the PRB 5 to the master device. Figures 3-1
and 3-2 on the next page show interface schematics for both connectors and
summarize the cable layout for a typical Pow-R-Boot 5 installation respectively.
3.2.1 C
ONNECTING
The PRB 5's RS232 port is a DB9 male connector wired in a DTE
configuration similar to that of an IBM
AT modem cable (our product code EVMBMC) to connect this port directly
to a modem.
3.2.2 C
ONNECTING
The PRB 5's CPM port is an RJ-11 jack, pinned so that you can run a straight-
through-pinned 6-wire twisted-pair cable (our product code EYN725MS)
or flat-satin cable (our product code EL06MS) from the CPM port to the
RJ-11 jack on one of our Port Manager Switches (product codes
SW545A and SW546A).
Do not connect devices to both the RS232 Port and the CPM Port at the
same time.
12
D RS232 P
EVICES TO THE
D CPM P
EVICES TO THE
ORT
® PS/2 ® , AT ® computer. Use standard
ORT
NOTE