Cleaning The Cab - Toro 31232 Operator's Manual

Cleaning the Cab

Important:
Use care around the cab seals and
lights (Figure 24). If you are using a pressure
washer, keep the washer wand at least 0.6 m (2 ft)
away from the machine. Do not use the pressure
washer directly on the cab seals and lights or
under the rear overhang.
Figure 24
1. Seal
2. Light
g034330
3. Keep wand 0.6 m (2 ft)
away.
4. Do not pressure-wash
under the rear overhang.
Storage
Remove the cab unit for storage during the warmer
months.
Preparing the Machine for
Cab Removal
1. Move the machine underneath the cab hoist,
shut the engine off, and remove the key from
the ignition.
2. Chock the wheels to prevent the machine from
moving during the installation.
3. Allow the engine to cool before you start the
procedure.
4. Drain the engine coolant.
Removing the Cab
1. Connect the cab hoist to the 4 lift points on the
cab (Figure 7).
2. Disconnect the heater hoses, install the
appropriate dust cover into the hose ends, and
install the engine plugs to the ports
and (Figure 13).
3. Remove the bolts, the washers, and the locknuts
securing the cab to the machine
Note:
Return the all of the hardware you
removed to the original mounting location in the
order that it is used to secure the cab to the
machine. This will prevent losing the mounting
hardware and simplify installation.
4. Raise the cab to a height that will allow you to
safely move the machine away from the cab.
5. Move the machine away from the cab.
6. Lower the cab onto a carrier to allow you to
move it to a storage location.
Note:
Secure the wiring harness and hoses
to prevent damage when lowered or stored.
Cover the cab to prevent dust and debris from
accumulating on it during storage.
7. Install the ROPS to the machine before
operating the machine.
21
(Figure 11)
(Figure 8).