Preparing The Machine - Toro 31232 Operator's Manual

1

Preparing the Machine

No Parts Required
Positioning the Machine
1. Clear a location in your workspace under the
hoist system.
Note:
Verify that your hoist system is capable of
safely supporting the cab unit over the machine
during the installation.
2. Move the machine to the workspace, lower
the mower decks, shut off the engine, set the
parking brake, and remove the key from the
ignition switch.
3. Allow the engine coolant to cool and then drain
the coolant from the machine; refer to the
Service Manual.
Removing the ROPS
Remove the ROPS from the machine and store it in
an appropriate area.
Important:
Have an assistant help you remove
the ROPS from the machine.
5
Figure 1
g031185