Key Whitelist; Merchandising - MTI CX FLEX Single-Power Product Manual

KEY WHITELIST

1 Place Authorization Card over the
RFID icon to register to system.
LED will be solid blue.
System must be disarmed
to perform this operation.

MERCHANDISING

1
Plug the USB-C end of the sensor into the CX Flex until it
clicks.
2b
Flexi-Disc Sensor: Peel the red film from the VHB
adhesive and press firmly onto the product for 1
minute if the product surface is curved, or 30 seconds
if it is flat.
www.mtigs.com | T:800.426.6844
Place the User Key over the RFID
2
icon you want to add.
If successful  unit beeps 2 times
If unsuccessful  unit beeps 4
times (retry)
Repeat process for all User Keys
until they are successfully added.
click
CX FLEX™ SINGLE-POWER PRODUCT MANUAL
3
2a
USB-C Sensor: Insert the other end of the cable into
the device.
3 System will auto-arm after 1 minute, or arm
immediately by holding a whitelisted User Card over
the RFID Icon.
MTI P/N 063-00308 rev 2 ©2019 MTI All Rights Reserved
To close the whitelist mode, place
the Authorization Card over the
RFID icon. Whitelist mode will end
automatically after 3 minutes of no
use. LED will be flashing white.
3