Materials In Box; Installation - MTI CX FLEX Single-Power Product Manual

Table of Contents

Advertisement

MATERIALS IN BOX

INSTALLATION

1
Clean the desired surface with an alcohol pad allow it to
completely dry. Peel the red film from the VHB adhesive.
3a
Use the individual power supply and plug it into
the nearest outlet. Use an outlet installed near the
equipment that is easily accessible.
www.mtigs.com | T:800.426.6844
CX FLEX™
Single-Power
Barrel
Female End
CX FLEX™ SINGLE-POWER PRODUCT MANUAL
Optional Power Supply
(400-00054)
2
Feed power cable through hole in fixture (if needed),
and press down on the base plate for 10 seconds for full
VHB contact. Allow 24 hours for full VHB adhesion.
3b
Alternately, use the Power Supply provided with
the product you are intending to secure, with the
appropriate adapter.
Use only certified AC main power supply adapters compliant
with Limited Power Source (LPS); use of other power supply
may cause malfunctions and electrical hazard.
MTI P/N 063-00308 rev 2 ©2019 MTI All Rights Reserved
Barrel
Male End
2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CX FLEX Single-Power and is the answer not in the manual?

Table of Contents