Use Of Your Barbecue - BORETTI IBRIDO TOP User Manual

4

. Use of your barbecue

4.1 General information
Although all gas connections on the barbecue are tested for
leaks before transport, a full test must also be carried out at the place of
assembly. Parts may have shifted during the transportation or assembly
of the barbecue. The gas pressure on the barbecue may also be too
high. Check the entire system for leaks regularly and check the system
immediately if you smell gas. If in doubt, shut off the gas supply.
4.2 Gas leak test
Always carry out a gas leak test prior to using the barbecue and after a
longer period of non-use.
Extinguish any open fire (DO NOT SMOKE while testing for leaks).
Never carry out this gas leak test near open fire.
Make a soap solution that consists of equal parts of water and liquid
soap or a mild detergent.
Follow the steps below:
1. Turn off the control buttons of the burners.
2. Remove the battery from the electronic igniter.
3. Open the gas cylinder.
4. Apply the soap solution to all connections on the gas supply. If no
soap bubbles are formed, there is no gas leak. If bubbles form on a
connection, it means there is a leak there. If you have detected a leak,
immediately shut off the gas supply, tighten all leaking connections,
open the gas cylinder again, and repeat steps 1 to 4.
5. Turn off the gas supply.
6. Use the control buttons to turn the burners on for 10 seconds to
release the pressure in the hose and then turn the burners off again.
7. Remove the soap solution from the connections of the appliance with
cold water and dry it with a cloth. Check all gas connections before
each use (and after replacing the gas cylinder).
It is recommended to check the gas hose for leaks every year, even
if the gas cylinder has never been disconnected from the barbecue.
11