Verify Configuration; Verify Addressing; Verify Devices; Verify Host Configuration - ADIC FCR 200 Operator's Manual

7-6 Troubleshooting

Verify Configuration

A number of configuration changes may result in an invalid
configuration. If you are in doubt about the configuration,
restore the FCR200 to the factory default configuration and
proceed to configure the unit a step at a time, verifying the
functionality of the configuration as changes are made.

Verify Addressing

If working in FC-to-SCSI target mode and using Indexed or
SCC Addressing, try swapping to Auto Addressing to see if
this solves the problem.

Verify Devices

It may be useful to connect the target devices you are
attempting to use to the native interface to verify that the
devices are functional. SCSI target devices can be connected to
a host SCSI bus to verify they are functional.

Verify Host Configuration

In some cases, it may be that the host bus adapter or driver
may not be working properly. Check the configuration of
these elements. It may be useful to check the release notes for
the driver provided to see if there are any specific issues or
required configuration. It may also be useful to ensure that
you are using a current version of the host bus adapter driver.

Verify HBA Device Driver Information

Check the HBA device driver Readme file for configuration
specifics. An HBA may require a different configuration,
depending on whether it is connected to a loop or a switch.
62-9301-01